Push Video Device to client?

[Different Computers]

I can't seem to figure out if there's a way to push the display of a video device to a client. I'd like the video feed to pop up like a control page when a particular trigger fires.

Possible?

[norcoscia]

A few years ago I did something like that - trigger fired and it switched to a different control page with the video, then it switched back after a set time. Let me see if I can find it…

Used trigger (see below) to switch control page - then next action delayed by 50 seconds send it back (same action a first one but points it back to the original control page).

[Different Computers]

This was my first thought too. But the video feed is not a control page, and can't be imbedded in a control page, unless I'm missing some other trick there.

[norcoscia]

I’m using security spy for that - I think I remember you said you have security spy as well as Camect (like me). If so and you can use security spy for your video I can post how it is set up.

[Different Computers]

Alas, no security spy. Camect only.

[norcoscia]

Likely it can be done if your camera works with a web browser but I would not be the person to ask - maybe someone else has some ideas, good luck and sorry I could not help…

[RogueProeliator]

I can't seem to figure out if there's a way to push the display of a video device to a client. I'd like the video feed to pop up like a control page when a particular trigger fires. Possible?

No, but can consider it for an enhancement in the near future... is this for an always-showing console in the home or on a mobile device? There are some restrictions on mobiles about directly showing foreground content from a notification, but reacting to it while DP is already up is definitely doable.

Adam

[Different Computers]

Yup, for me it would be an always on, always domopad in the foreground situation.

Awesome, thanks in advance!