Basic question about creating a Enphase Envoy device.

jstackmk · Post by **jstackmk** » Sat Dec 24, 2022 12:11 pm

I have a new Enphase system and am trying to use this plugin. When I create an Enphase Envoy-S device it only asks for the IP address. It doesn't ask for the serial number. I attached a screenshot and error in log.

It creates the device but it is offline.

GlennNZ · Post by **GlennNZ** » Sat Dec 24, 2022 3:18 pm

Hi

We no longer need the serial no as can usually be pulled from data received.

For some reason - that IP address is not returning the usual Envoy-S data:
Error 301

Either IP address is wrong
Or your device is not a Envoy-S
Or there has been some major change I am yet to see.

Glenn

Sent from my iPad using Tapatalk

jstackmk · Post by **jstackmk** » Sun Dec 25, 2022 6:49 am

ok, I have the IQ Gateway, not the Envoy-S.
Oh well.
Thanks Glenn

GlennNZ · Post by **GlennNZ** » Sun Dec 25, 2022 3:28 pm

Pretty sure thats the same thing - they have just renamed it.

Go to your IP address of the device in a Browser and paste what you see…
& then try

http://Ipaddressofdevice/info.xml

Edit:

Firmware 7+ appears to be an issue. With most integrations breaking.

It needs Token authentication and most things seem locked down.

I would guess the first web-browser info above will have you on Firmware 7+

It is fixable - although needs a reasonable amount of work to add the token exchange. (token generation is with enphase online website). No ETA from me on this….

Sent from my iPad using Tapatalk

jstackmk · Post by **jstackmk** » Mon Dec 26, 2022 6:34 am

here it is

Thanks

GlennNZ · Post by **GlennNZ** » Mon Dec 26, 2022 3:23 pm

Yep.

Firmware 7 - which now needs a token authentication exchange with enphase servers to access the simple data that previously was open. I presume also that the info.xml page is also gone, hence seem to need to manual enter serialNo again.

Will have a look.

Sent from my iPad using Tapatalk

Indigo Domotics