Erroneous ZWLM notification from Kwikset lock

[dduff617]

ZWave Lock Manager sometimes gives me notifications of events for one of my Kwikset locks which seem erroneous. this happens to be one of my older kwikset locks a model 910, which i think is equivalent to a model 912.

i get notifications like this:

Code: Select all

  Z-Wave Lock Manager             Status: Invalid code limit exceeded [Node: 26]

i get these at times when no-one is entering any codes. my assumption is that "invalid code limit exceeded" would be a message you would get if someone were repeatedly trying to open the lock by entering codes and had exceeded some limit of bad codes within a certain time period. however, that's definitely not what is happening when i get these messages.

anyone else seen this? is it a possible error in ZWLM? or an error in the implementation or documentation by kwikset? suggestions?

below are the details of the z-wave device;

Code: Select all

Indigo Z-Wave Version: 2023.1.0
Node ID: 26
Model: SmartCode Lock (910)
Model ID: 00010001
Manufacturer: Kwikset
Manufacturer ID: 0090
Protocol Version: 3.67
Application Version: 3.37
Model Definition Version: 0
Library Type: 6
Class Name: Keypad Door Lock
Class Hierarchy: 04 : 40 : 03
Command Class Base: 62

[FlyingDiver]

If it's an older lock, maybe there's been some water penetration that's shorting the keys and causing it to think the buttons are being pressed.

[dduff617]

thanks for the suggestion. the lock is essentially indoors (lock sits between my house and an enclosed garage), so i don't think water infiltration is the problem.

possibly i will watch for a sale and grab a new/updated lock at some point.

[howartp]

If this is happening frequently, can you put the plugin in debug mode (plugins > ZWave Lock Manager > Configure) then send me the "Raw: ......." line that appears in the log when it happens.

Peter