I/O linc - turn on/off input?

[thomasw]

HI Adam,
DomoPad is working for everything except for an I/O Linc. In my indigo system, I have an I/O Linc that controls the pwr to my secondary Wifi router.
When the input #1 is turned ON, it connects the 5 volt + wire connection to the Wifi router, and turns the pwr on. On the iphone Indigo Touch App, I could just turn On or Off the input #1 of this I/O Linc with no problems.
In DomoPad for Android, it shows the I/O Linc in the Devices, and it even shows the state of the input, but it won't allow me to turn On or Off the input?
Any way to fix this?

[RogueProeliator]

I'll look into this - it is likely a bug or a mis-identification of the device type/capabilities. Could just be an oversight.

Adam

[greenhornet]

I'm having the same issue on my io linc that controlls my garage door. It works fine on the iOS side.

[thomasw]

Hi Adam,

Have you had any time to look at the issue of the I/O linc control in DomoPad yet?
It shows up fine, but I can't turn the output ON or OFF .

[RogueProeliator]

No, unfortunately I have not... I'll get to it at some point. There is a very simple workaround for you though -- you can create what amounts to your own popup actions in the device list by creating a very simple control page with an On and Off button, perhaps a status; then link that control page to the device action as detailed in HOWTO: Custom Device List Action Popups. Should just take a few minutes to setup a basic popup.

Adam