I just purchased a 2414U and am trying the trial of Indigo 4.0.2.
I'm running a uni-body MacBook Pro on Leopard 10.5.7. (I've also tried this on my wife's new iMac)
I haven't been able to successfully setup a single device using Indigo and the 2414U. I'm trying to control some LampLincs. I also have 20-some SwitchLinc Dimmers.
Indigo successfully connects to the 2414U but when i try to add a device, it doesn't auto-sense the address of the device when I hold the set button or paddle-top. So I manually enter the address and click Start. It tries 10 times to connect and then I get the error: "Failed to establish a link with the device."
I see this in the log 10 times before it gives up:
PowerLinc Linking - sending id request for device information
PowerLinc IndigoApp Running
PowerLinc IndigoApp Initialized
And when the linc is being attempted I see the blue LED on the PowerLinc blinking and flashing and I even see the LED on the LampLinc sometimes blink in response.
I have the PowerLinc plugged directly into the wall. The lamplinc is plugged directly into the pass-through port on the PowerLinc. The provided USB cable is plugged directly into a usb port on the laptop.
2414U firmware: 2.13
I've tried 4 or 5 different LampLincs & SwitchLincs. I've tried 4 or 5 different outlets in the house.
For testing purposes I was ablet to get the PowerLinc to control some devices using Shion for Mac as well as mControl for PC. (note: I saw no indication that those pieces of software were receiving any signals FROM the devices)
In the interest of full disclosure, I do NOT have any wireless Access Points installed in my Insteon system. So far, the system has worked quite well without them. I'd be surprised if that's the cause of this problem. But you guys know better than me.
Thanks.
-Andrew