aaronlionsheep wrote:roquej wrote:I use the Shelly-1 with homebridge and the reed switch output works. So, I think it's configured properly.
JP
Do you mind confirming the value coming from the Shelly 1 over MQTT? Specifically, is the value from the topic
- Code: Select all
shellies/<your_device>/input/0
a "0" or a "1" when the switch input changes? I'm wondering if a recent Shelly firmware update changed the value they are sending.
Via MQTT Explorer, shellies/shelly1-98F4ABF2A1ED/input
The relay works from Indigo and all states changes are seen in MQTT Explorer. However, if you look at the relay states:
Side Gate relay (Shelly-1) states firmware-version
Side Gate relay (Shelly-1) states has-firmware-update False
Side Gate relay (Shelly-1) states ip-address
Side Gate relay (Shelly-1) states longpush False
Side Gate relay (Shelly-1) states mac-address
Side Gate relay (Shelly-1) states onOffState False
Side Gate relay (Shelly-1) states online True
Side Gate relay (Shelly-1) states sw-input False
None seem to change when you trigger the relay, which again, works to trigger the Side Gate.
Very confused right now.
This is the MQTT Trigger definition: