Requirements:
• An ad2usb alarm interface connected to an alarm panel supported by the ad2usb.
• The ad2usb must have the most current firmware.
See http://www.nutech.com/index.php?option= ... id=4&id=21
• Indigo 5.0.4 or later
Limitations:
• Identification of the user code used to arm/disarm the panel requires the new v2.2 ad2usb board.
• Some limitations may exist on 20E panels.
• Passwords (user codes) are not stored in the plugin. The user may choose to store codes in Indigo actions if he or she chooses.
• Only partition 1 is supported.
• Only a single virtual keypad device is supported.
• This plugin has not been tested with panels using zone doubling on the main board.
• The ad2usb must have the most current firmware.
mattyf wrote:I'm still having trouble with this... let me narrow down the question.
When I create an action to "Arm-Away" the panel, when the Configure Arm Away box opens, I have nothing to choose from in the pop-up menu *see Screenshott attached." Is this correct?...
gt3mike wrote:Might be worth searching the thread. I can’t check how I arm my panel via the plugin right now, but I seem to recall that some of the plugin actions don’t work.
Users browsing this forum: No registered users and 0 guests