Change parameters on Aeotec Siren gen6

Posted on
Fri Jul 03, 2020 5:08 am
boekweg offline
Posts: 63
Joined: Oct 02, 2010
Location: Netherlands

Change parameters on Aeotec Siren gen6

I want to use an actiongroup to set the sound volume of the siren6 to 30% during nighthours and 60% during the day, by changing a configuration parameter. The siren is used as a doorbell as well. I have read through the engineering specs of the device but can not figure out which parameter I have to set to alter the volume of button 1 of the siren. Is there someone that has experience in this?

Posted on
Tue Jul 07, 2020 5:39 pm
matt (support) offline
Site Admin
User avatar
Posts: 20088
Joined: Jan 27, 2003
Location: Texas

Re: Change parameters on Aeotec Siren gen6

Which specific model are you trying to use? The ZW164? If so that one doesn't use Z-Wave configuration parameters for the volume. Instead you can try sending a raw Z-Wave command that has this format:

Code: Select all
0x79 0x05 newVol newTone

where newTone is:

1 Ding Dong
2 Ding Dong Tubular Bell
3 Traditional Apartment Buzzer
4 Electric Apartment Buzzer
5 Westminster Chimes
6 Chimes
7 Cuckoo
8 Traditional Bell
9 Smoke Alarm (low
10 Smoke Alarm (high
11 Fire Evacuation Buzzer
12 Carbon Monoxide Sensor
13 Klaxon
14 Klaxon (deep
15 Warning Tone
16 Tornado Siren
17 Alarm
18 Deep Alarm Tone
19 Alarm (archangel tone
20 Alarm (shrill
21 Digital Siren
22 Alert Series
23 Ship Bell
24 Clock Buzzer
25 Christmas Tree
26 Gong
27 Single Bell Ting
28 Tonal Pulse
29 Upward Tone
30 Door Open

Image

Posted on
Mon Jul 13, 2020 11:11 am
boekweg offline
Posts: 63
Joined: Oct 02, 2010
Location: Netherlands

Re: Change parameters on Aeotec Siren gen6

Thanks Matt, indeed it's the ZW164. I will try the raw command.

Page 1 of 1

Who is online

Users browsing this forum: No registered users and 0 guests