General Electric ZW-4005 in wall switch

Posted on
Sun Nov 18, 2018 12:04 pm
PMack offline
Posts: 8
Joined: Nov 07, 2018

General Electric ZW-4005 in wall switch

Moving from VeraEdge, have a few GE ZW4005 switches that won't include or sync, My question is, are these switches compatible with Indigo, or am I doing something wrong on the install.
Thanks.
Peter

Posted on
Sun Nov 18, 2018 12:25 pm
autolog offline
Posts: 2461
Joined: Sep 10, 2013
Location: West Sussex, UK [GMT+0]

Re: General Electric ZW-4005 in wall switch

If they were already working on the VeraEdge , in Indigo, have you excluded them before trying to include them :?:

Posted on
Sun Nov 18, 2018 12:37 pm
PMack offline
Posts: 8
Joined: Nov 07, 2018

Re: General Electric ZW-4005 in wall switch

I have done an exclude, also factory reset, and I have a new one, close to the controller, But so far no luck.
Thanks,
Peter

Posted on
Sun Nov 18, 2018 12:41 pm
autolog offline
Posts: 2461
Joined: Sep 10, 2013
Location: West Sussex, UK [GMT+0]

Re: General Electric ZW-4005 in wall switch

I haven't got one of these devices, so I am just making general Z-Wave comments. :)

Have you got a Z-Stick and if so are you using the Indigo UI to exclude/include or are you using the button on the Z-Stick?

Posted on
Sun Nov 18, 2018 12:42 pm
PMack offline
Posts: 8
Joined: Nov 07, 2018

Re: General Electric ZW-4005 in wall switch

AND after doing include and exclude, factory reset lots of times, it enrolled just fine.
Not sure why, but success is always fun.
Thanks,
Peter

Posted on
Sun Nov 18, 2018 12:50 pm
autolog offline
Posts: 2461
Joined: Sep 10, 2013
Location: West Sussex, UK [GMT+0]

Re: General Electric ZW-4005 in wall switch

Well done - glad you got it working :D

Page 1 of 1

Who is online

Users browsing this forum: No registered users and 0 guests

cron