1142 bugs maybe? Overall, it seems to be working, after setting up a couple sensors on my SBC2. I have the combined temp/humidity (1125) hooked to sensor ports 0 an 1, and I have the 1142 0-1000 light sensor in port 4.
Temp and humidity look about right to me, based on another instrument in the room (though not in the same exact location). They also change, if say I hold the sensor in my hand for a bit.
The light sensor has a couple things going on:
- the values it reports do not match the values I see in the phidgets app, if I open the interface kit from the phidgets preference pane. In the preference pane app, using an LED lamp I have at my desk, it reads a maximum of about 775 if I hold the sensor to the bulb. With the Indigo plugin, it reads almost 1200 with the sensor in the same spot. At the low end, I can get the phidget app to show down to 6-7, and in Indigo, it shows 38-40.
- For a short period after reloading the plugin, I was getting this message in the Indigo log, any time the light sensor value changed (the same error streamed over and over to the log). Then, it quit showing up, but I didn't change anything:
Error device state key brightness not defined (ignoring update request)
- When I define the light sensor device, all the selection options are as you would expect. I see all 8 sensor ports to choose from when I need to tell the plugin what port my light sensor is on. However, if I edit the light sensor after I've created it, it only gives the options of ports 0 or 1.
I have a few other sensors to experiment with over the next few days. Thanks again for the work on this!