There is a config to change controlling the
load, but I haven't changed that. A single press UP turns the load ON but registers as a down tap, and a single press DOWN turns the load OFF but registers as an up tap.
And just for grins, I did change the paddle behavior, so a single tap DOWN turns on the load, but even then it still reports as an UP tap. I'm guessing this COULD be a bad switch, but also allowing for the possibility that the device definition in Indigo has this reversed.....
Although this is the only ZEN76 that I have, I do have a ZEN77, which is the dimmer version so I assume it has similar software, and it registers taps correctly... And other Zooz switches also register taps correctly as well.
Like I said, no big deal.. just more curious than anything else.
Here is the link for the Advanced Parameters. Perhaps its there and I just missed it...
https://www.support.getzooz.com/kb/article/549-zen76-s2-on-off-switch-700-advanced-settings/