- Posted on
Tue Apr 07, 2020 5:44 pm
-
farberm
offline
-
- Posts: 393
- Joined: Feb 24, 2008
I would appreciate any input from prior installers. Here is what I found for programming the 8E serial port on the Caddx *E system
SERIAL PORT COMMUNICATION
Loc'n Loc'n Description Value Interpretation of Value
207 Serial Port Enable. 01 Home Automation Protocol*
208 Serial Port Baud Rate. 02 9600 bps
209 Home Automation Protocol (vice printer) "1-------" ASCII mode
210(1) NX-8E Broadcasts Enable flags (NX-8E) Intf Cfg at pwr up, Zone Status, Zones Snapshot, Partition Status, Partition Snapshot
210(2) "Nx-*E automatically send System Status, Log Event Msg, Kpd Msg Rcvd
211(1) NX-584 Command Request Enable flag Interface Config, Zone Name, Zone Status, Zones Snapshot, Partition Status, Partitions Snapshot
211(2). Sys Status, Log Event, Kpd Txt, Kpd Term Mode
211(3). Pgm Data Rqst, Pgm Data Cmd, User Info Rqst w/PIN,Set Usr Code w/PIN, Set User Auth Cmd w/PIN
211(4) Stor Comm Event Cmd, Set Clk/Calendar, Primary Kpd Func w/PIN, Prim Kpd Func wo/PIN, Sec Dpd Func, ZoneBypass Toggle
I found 3 different options but think these are close
207 1. On
208 2 9600
209 SHOULD BE BINARY -------- all off
Location.
210 (1). -2–5678
210 (2). 1234----
211 (1) -2-45678
211 (2) 12345—
211 (3) 123-5-7-
211 (4) --345678
Not sure these are correct but anyone else with an 8E board please let me know.
Last edited by
farberm on Tue Apr 07, 2020 8:13 pm, edited 1 time in total.