Adding the Relay Power Switch (an Inovelli NZW36 1-Channel Plug-In Module) went just fine - both Z-Wave network inclusion and syncing.
Different story with the Lock, which is a nifty new Danalock V3 (https://danalock.com/danalock-v3.html), Z-Wave US version. Inclusion into the Z-Wave network worked fine, and it shows up in the node list for syncing when creating a new Z-Wave device in Indigo. But, when I press Sync, it looks promising... but then gets stuck waiting for an ACK from the Lock and times out. Tried multiple times, excluding then re-including, moving the physical position of the lock compared to the Z-Wave stick on my Mac, poking and prodding the lock to make sure it was never asleep.... and no luck.
My Z-Wave interface from Indigo is via an Aeon Labs Aeotec Z-Wave Z-Stick, Gen5 (ZW090).
Any ideas? Here's some relevant event log output - happens in rapid succession, then just hangs and times out after the 'retrieved manufacture..." line; this log output is consistent across all of my attempts.
- Code: Select all
Z-Wave Syncing - started for "032 - Keypad Door Lock"
Z-Wave Syncing - retrieved module neighbors list: 31
Z-Wave Syncing - assigning return route to "032 - Keypad Door Lock"
Z-Wave Syncing - assigned return route
Z-Wave Syncing - retrieved manufacture and model names: Danalock - 010E, Danalock (V3 BTZE) - 00090001
Z-Wave Error Syncing - failed
Z-Wave Error Timeout waiting for "032 - Keypad Door Lock". Module might be asleep, or is unreachable.
Seems like the lock just isn't interested in ACK'ing.