Hi - thanks for coming back on this
Beacon data debug set to on..
- Code: Select all
pi@raspberrypi:~ $ tail -f /var/log/piBeacon.log
UP RUNNING
RX bytes:1581 acl:0 sco:0 events:103 errors:0
TX bytes:5069 acl:0 sco:0 commands:103 errors:0
20190701-21:32:22 beaconloop L:-1= my BLE mac# is : B8:27:EB:B2:3E:A2
20190701-21:32:22 beaconloop L:-1= ble thread started
20190701-21:32:22 beaconloop L:-1= starting loop
20190701-21:32:23 master L:-1= IP find:: IPs#: Indigo>192.168.2.2<; wlan0>192.168.2.40<; eth0><; hostname>['192.168.2.40']<; AddressFile>192.168.2.40<; PKTS(eth0>0,0<; wlan0>73,55<, dTime:4.2)
20190701-21:32:23 master L:-1= Requested Config:{u'wlan0': {u'on': u'on', u'useIP': u'use'}, u'eth0': {u'on': u'off', u'useIP': u'doNotUse'}}
20190701-22:06:22 master L:-1= dosfsck has error (was fixed after boot): fsck.fat 4.1 (2017-01-24)/--/Checking we can access the last sector of the filesystem/--/0x41: Dirty bit is set. Fs was not properly unmounted and some data may be corrupt./--/ Automatically removing dirty bit./--/Boot sector contents:/--/System ID "mkfs.fat"/--/Media byte 0xf8 (hard disk)/--/ 512 bytes per logical sector/--/ 512 bytes per cluster/--/ 32 reserved sectors
and it hangs here
ETH and WLAN parameters are as shown in attachment for both config and rPI edit