After not using the plugin since a very long time - in general, in 2017/2018 I had not too much time for Indigo , I wanted to start from scratch with it and mostly connect sensors (first of all a CO sensor).
But I'm not able to setup up the Pi via the Plugin, can't do the initial setup.
For sure I'm doing something wrong, or I forgot something, so, I'm asking for help
What I've done:
1 . installed Pi (has another IP-address now as the last Pi), is accessible via Wlan, can connect via ssh, everything done on the image (expanded, changed pwd., etc.). Using the latest image.
2. deleted the old PiBeacon folder from Documents
2. installed the latest plugin
4. configured the plugin
5. now I'm stuck at the initial setup, where I have to select a Pi, not shown there with the ip-adress.
What do I have to select? 0? or Only sensor? Nothing is shown, as far as I know, it should show it, or I have to specify it
Thanks,
Yassi