Hello Everyone,
I just received my Z-Stick Gen5 and two Ecolink motion sensors PIR-zwave2.5-eco today.
The motion sensors seems very slow. After I move my hand in front of the sensor the LED on the front takes about 15 seconds to flash and once it does flash Indigo gets the command within 1 second (very fast)
Is this normal?
The way I set it up is:
-Setup Z-stick on Serial Port usbmodemFA121
-added the eco link in devices
-setup a trigger Type=Z-Wave Command Received, Event=Incoming Command Received from Device, From=003-Notification Sensor, Received=Match Raw Packet, Match bytes=0x01 0x0A 0x00 0x04 0x00 0x03 0x04 0x30 0x03 0x00 0xFF 0x3A
Is this the correct setup?
Shouldn't we see when the motion is activated from the devices folder. The state of the device never changes from off.
Also Indigo only gets the motion trigger from one of the motion sensors. The other seems like doesn't even work. Both are setup the same way.
Is it normal for this motion sensor to take 15 seconds to detect the motion?
What should I check with the second sensor to make it work?
And most important, what sensors are y'all using? I need something fast.
Thanks for the help
Edmond