The strange thing is that sometimes the harmony is not reacting when I run a activity. It is not showing any errors. Every time I run a activity it says
- Code: Select all
,errorCode = 200, errorString = OK
Any tips on how to investigate further?
,errorCode = 200, errorString = OK
Harmony Hub Debug Harmony Ultimate HUB: Start Activity - Hør på SONOS
Nov24 2016 12:47:21
Harmony Hub Debug Harmony Ultimate HUB: Time out in hub.client.startActivity
Nov24 2016 12:47:51
WebServer request to execute "Universalfjernkontroll" control #14 from 80.254.154.91
Action Group Harmony HUB - Power OFF
Harmony Hub Debug Harmony Ultimate HUB: Power Off
Nov24 2016 12:48:23
WebServer request to execute "Universalfjernkontroll" control #20 from 80.254.154.91
Action Group Harmony HUB - Listen to SONOS
Harmony Hub Debug Harmony Ultimate HUB: Start Activity - Hør på SONOS
Harmony Hub Debug Harmony Ultimate HUB: messageHandler: Event state notify, activityId = 15935745, activityStatus = 1
Harmony Hub Debug Harmony Ultimate HUB: messageHandler: Event state notify, activityId = 15935745, activityStatus = 2
Harmony Hub Debug Harmony Ultimate HUB: messageHandler: Event startActivityFinished, activityId = 15935745, errorCode = 200, errorString = OK
Harmony Hub Debug Harmony Ultimate HUB: messageHandler: Event state notify, activityId = 15935745, activityStatus = 2
Nov24 2016 12:48:51
WebServer request to execute "Universalfjernkontroll" control #14 from 80.254.154.91
Action Group Harmony HUB - Power OFF
Harmony Hub Debug Harmony Ultimate HUB: Power Off
Harmony Hub Debug Harmony Ultimate HUB: messageHandler: Event state notify, activityId = 15935745, activityStatus = 3
Harmony Hub Debug Harmony Ultimate HUB: messageHandler: Event state notify, activityId = -1, activityStatus = 0
Harmony Hub Debug Harmony Ultimate HUB: messageHandler: Event startActivityFinished, activityId = -1, errorCode = 200, errorString = OK
Harmony Hub Debug Harmony Ultimate HUB: messageHandler: Event state notify, activityId = -1, activityStatus = 0
ryanbuckner wrote:I have a similar problem. Most of the time t works flawlessly but every once in a while Alexa says "OK", sends the command, and nothing happens.
FlyingDiver wrote:That message is reporting a timeout from the low level xmpp messaging framework. It may or may not mean anything useful.
Does your activity change not happen when you get that message? Does it only happen on specific activity changes, or only when the hub has been inactive for an extended time? Or does it happen when you're sending a bunch of commands?
I could possibly attempt to send the command again when I get that specific error. I'd need to be careful how many times it retries.
Users browsing this forum: No registered users and 1 guest