Karl
updated to 4.16.8, still having some troubles.
I decided to delete the old plots since there was so many changes to them, also deleted most of the devices and do a fresh start,
First added the wireless office motion with state of on/off and faulted as events, looks like the on/off was excepted ok but I don't
think the faulted worked. It does show up in the plot list of sources.
in plot setup I can select the on/off for the line and the chart works fine. If I select the fault from the list (it is available in the list)
but it does not show in source A. and I can not make any other changes until I leave the setup and go back. so using the on/off
seams to work but not faulted.
After getting the first line working went back to the plugin setup started adding a few more sources as on/off. Added two more with no trouble, when adding one
more it would not add any device from the list and showed an error of nothing selected.
Did a reload of the QSL data base and after that was able to add an two more sources.
added the new sources to the plot for a total of 5 lines and it is working fine.
Still will be adding more sources and lines but I will see how it works for a little bit.
Drop box below is a few notes and loges from adding the above
Hope it does get you confused as what I was doing
Elwood
https://dl.dropboxusercontent.com/u/329 ... 20logs.rtf