Ok
So on day 6 of Indigo
For an experiment I urned On EVERY Receiver Protocol on the RFXCOM
A nice surprise was that it picked up the two TFA Temperature sensors (although reporting +40C than the actual temperature )
Both sensors report every 50 odd seconds.
I am trying to detect which Protocol the RFXCOM is picking these sensors up on - I cant see anything in the Log except-
4 Apr 2016, 14:18:21
RFXCOM Debug processing: 8 80 7 15 183 0 2 107 121 (08 50 07 0F B7 00 02 6B 79)
RFXCOM Debug Temp sensor 183 now 61.90 degrees and 0 humidity.
RFXCOM Debug Temp sensor 183 in list
Trigger Temp Sensor
RFXCOM Debug UpdateMinMax state temperature value 61.9
RFXCOM Debug check if new day: last date 2016/04/04, new date 2016/04/04
RFXCOM Debug UpdateMinMax state humidity value 0
RFXCOM Debug check if new day: last date 2016/04/04, new date 2016/04/04
RFXCOM Debug ++++++++++++++
4 Apr 2016, 14:18:40
RFXCOM Debug processing: 8 80 7 16 64 0 2 4 121 (08 50 07 10 40 00 02 04 79)
RFXCOM Debug Temp sensor 64 now 51.60 degrees and 0 humidity.
RFXCOM Debug Temp sensor 64 in list
RFXCOM Debug UpdateMinMax state temperature value 51.6
RFXCOM Debug check if new day: last date 2016/04/04, new date 2016/04/04
RFXCOM Debug UpdateMinMax state humidity value 0
RFXCOM Debug check if new day: last date 2016/04/04, new date 2016/04/04
RFXCOM Debug ++++++++++++++
I can't see which protocol this is using.
I have doing some tests of elimination,
It took about 10 minutes it is coming in on the Viking Protocol
Is there a quicker way than suck and see?