Since a while, I have the CM15 interface causing problems.
To be honest, since z-wave, my only device remaining X10 was a switch in my top-fan, all others are motion detectors (MS13) and commanders RF (SS13).
Very often while I sent a ON or OFF command to the fan (AW12), it was not working. Because of a trigger, it was reseting the interface (when Interface Failure : Reset interface connection).
But most of the time, I was not able to send the command again, was doing the same. After a while, finally sometimes, it works. Sometimes not.
Not I removed the AW12 that I replaced by a Z-Wave+ controller. Because my need is to keep the MS13 and SS13 working.
Unfortunately, it's still bugging.
I activated the error reporting in the CM15 and I have this line very often :
"undefined byte (18) from interface"
It really often and not only when receiving any RF commands from MS13 or SS13.
It's every minute or even a bit more.
If I make a reset I have this :
- Code: Select all
CM15 enabled internal RF to power line relaying
Connected to USB ActiveHome Interface
CM15 firmware version 2
CM15 disabled internal RF to power line relaying
Error undefined byte (18) from interface
And it's still not receiving commands. When I unplug and replug the CM15 in power outlet, it generally works a few seconds or minute only.
I tried to change USB port and so but it makes the same...
Do you have any idea or tips ?
Thanks !