Good Day .. I am new to Indigo 6 and so far I starting to understand and work with the software but…. And if I am in the wrong forum let me know so I can properly post.
Is there any way to expand the X10 signal monitoring ??
I have one room where 3 outlets and one wall switch will not respond.
Other outlets on the same circuit breaker seem to work fine ???
I have checked with a go/nogo phase tester and all seem to be valid
I have turned on (grin) my stove and oven & dryer .. that did not help (I do have phase coupler installed)
I have a few small questions:
Is there any way to expand the X10 signal tracing when a command is sent ?
Right now I only get the following when I send a Status Request:
May 21, 2014, 8:45:03 AM Sent X10 "Living Room" status request
Error timeout waiting for device Status Response
Is there any utility to send “probe” request for all connected X10 devices and produce a map with address and status in my setup?
Does anyone have any other suggestions or tips or guidelines ???
Thanks in advance
Jim Sterling
jasiii@comcast.net