Greetings
I'm looking for guidance on best practices on setting up an Action Group that will set the status of multiple keypads to on/off based upon one keypad being triggered in order to keep the states consistent. What I have setup now, when the Action Group is triggered from one keypad, it causes the entire set of Action Groups to repeat 5X (once for each keypad in the overall scene) which means there is a lot of traffic and if there is a drop in any data signal, it can go into an infinite loop (rare but has happened).
Current Setup
-Action Group 1: Insteon Recessed Can DIN Dimmers
-Action Group 2: Insteon Outlets
-Action Group 2: Keypads
Example: Pressing Key 8 on any keypad in the rooms in question will trigger the lights and outlets to go on/off as well as Key 8 on all of the keypads in the room to sync state with the actual keypad triggered.
Thanks for any insights.
Ryan