I have a use case where I'd like to do something triggered by something being plugged in. I have a z-wave ZEN15 zooz device and a insteon smart lamp dimmer. I tried to look at the debug output to see if I could match on something when I plugged both of them in but I didn't see that they sent any sort of status. the ZEN15 I checked doesn't have any parameter that I can set that would force it to send status or something when plugging in. The insteon doesn't seem to send anything either. I could of course poll the target device but I'd prefer not to if I can avoid it (wouldn't be the end of the world, but triggering on an event would be more economical obviously. I think the answer to this is no, but I know very little about the z-wave spec or the insteon wire protocol so just wondering if there's something I'm missing. Maybe I can't try to target a device in the listen to raw command trigger? or? something else?
Thanks