[ANSWERED]: Keep keypad buttons and FanLinc in sync?

Hi. I have been following the instructions on this wiki page http://wiki.indigodomo.com/doku.php?id=scenes_multiway_groups_overview to keep my virtual 3-way circuits in sync, and to also keep my devices controlled by keypads in sync with the keypad lights.

The one thing it doesn't tell me how to do is to keep a FanLinc in sync with a keypad. I have a keypad that has 3 buttons for the FanLinc - Fan High, Fan Medium, and Fan Low. I have them set as exclusive, so only one can be on at any time. If all are off, then the fan is off.

However, if I change the speed of the fan directly through Indigo, then the keypad buttons don't update. How can I add a trigger to keep them in sync? I don't think the FanLinc has AppleScript support, so I can't use the same approach as in that wiki article.

Thanks,
-Mike

[matt (support)]

Hi Mike,

Read over the wiki article below. The last section talks about a couple of possible solutions to keep the KeypadLinc LEDs in sync.

http://wiki.indigodomo.com/doku.php?id= ... lmost_done

Hi Mike,

Read over the wiki article below. The last section talks about a couple of possible solutions to keep the KeypadLinc LEDs in sync.

http://wiki.indigodomo.com/doku.php?id= ... lmost_done

Thanks. Got it working.

-Mike