I have a recurring issue with a small 110V waterfall pump turning off where it causes an apparent "glitch" on my insteon network resulting the 2413U PLM at least thinking the power went down. i.e.
Schedule Water Feature Motion Garage Sensor On Day (delayed action)
Power Failure possible power failure
Error "Water Feature Pump" off; send failed (no acknowledgment)
Trigger Error - In Log File
Email Sent to “xxxxxxx@yyyy"; subject "Indigo Error Detected"
Connected to PowerLinc 2413U interface on port usbserial-A501LDGN
PowerLinc address 1E.4C.93, firmware version 9.11
Interface Failure lost connection with interface
Trigger Power Outage Notification
Trigger Power Outage Restored
The sequence is always the same where I see a no ack from turning the pump off followed by an "interface failure" and an instantaneous reconnect (which explains why the order above is incorrect).
The waterfall pump in question is on the same electrical circuit as the PLM and is literally 90 feet away from it on a point-to-point cable.
Would a filter on the pump help here or does this seem like something different and peculiar?