Page 1 of 1

General Electric ZW-4005 in wall switch

PostPosted: Sun Nov 18, 2018 12:04 pm
by PMack
Moving from VeraEdge, have a few GE ZW4005 switches that won't include or sync, My question is, are these switches compatible with Indigo, or am I doing something wrong on the install.
Thanks.
Peter

Re: General Electric ZW-4005 in wall switch

PostPosted: Sun Nov 18, 2018 12:25 pm
by autolog
If they were already working on the VeraEdge , in Indigo, have you excluded them before trying to include them :?:

Re: General Electric ZW-4005 in wall switch

PostPosted: Sun Nov 18, 2018 12:37 pm
by PMack
I have done an exclude, also factory reset, and I have a new one, close to the controller, But so far no luck.
Thanks,
Peter

Re: General Electric ZW-4005 in wall switch

PostPosted: Sun Nov 18, 2018 12:41 pm
by autolog
I haven't got one of these devices, so I am just making general Z-Wave comments. :)

Have you got a Z-Stick and if so are you using the Indigo UI to exclude/include or are you using the button on the Z-Stick?

Re: General Electric ZW-4005 in wall switch

PostPosted: Sun Nov 18, 2018 12:42 pm
by PMack
AND after doing include and exclude, factory reset lots of times, it enrolled just fine.
Not sure why, but success is always fun.
Thanks,
Peter

Re: General Electric ZW-4005 in wall switch

PostPosted: Sun Nov 18, 2018 12:50 pm
by autolog
Well done - glad you got it working :D