As a fix for a Whirlpool controller gone bad I installed a Nano Switch (ZW139) to control the On/Off of the motor. But from time of key press (even in Indigo directly) to execution it seems to hang sending the request. Often if I send the status request it will then execute. I Optimized the network, tried syncing again but seems to have that problem continue.
Any suggestions or ideas I can try?
Update: I do see this in the log often.
Apr 5, 2018, 10:16:57 AM
Z-Wave received "Foyer Motion" status update is on
Z-Wave Error no nonce reply (066) for requestRelayStatus (re-sending)
Z-Wave received "Whirlpool" status update is off
Z-Wave Error no nonce reply (066) for requestRelayStatus (re-sending)
Z-Wave sent "Whirlpool" status request
Z-Wave sent "Whirlpool" status request