Z-Wave Greenwave 5 Port PowerNode (UK model) - more issues

Hello everyone,

I'm using the UK model for a few weeks and it is not a 'frustration' free time.

I have plugged in only two appliances to it and kept the other 3 sockets on just to see how it goes and for some strange reason I see through indigo 'load' on 3 of them? Where does the extra load go to as only two physical sockets are plugged in???

The problem goes away briefly with a "Define and Sync" but then appears again... Somewhere I read that there is a 'master' plug device in there that maybe indigo is getting confused?

I have it configured to be polled every 5mins - if that makes any difference.

Anyone else facing similar issues?

Thanks!

Kostas

You asked a similar / related question here: viewtopic.php?t=14146

That thread also has a link to another thread; between them they give (good?) info about this model - though a lot of it is from me, through trial and error.

Having said that, on this following thread, another user and myself have had issues with low-polling times on this device.

viewtopic.php?t=14149

The device appears to give false info if you poll it too often.

If you send it an on/off command it always responds with its new status and power draw for that socket, so you might find you don't need it on 5 minute poll?

Thanks howartp! I posted a new topic as I thought this might be a different issue.

I will change the polling and see what happens.

Kostas