Hello everyone,
I've been toying with the idea of beginning an automation network based on indigo domestics,software with the security spy plugin. But after going away for a week (which is one of the reasons for the remote automation system) my pool filter clogged and then continued to run burning out the pump. I would like to put the z-wave GE appliance switch on the unit and then have a pressure switch.
IE the schedule would be something like this(don't mind my thought process please!)
Schedule:
0000-0800 : OFF
0800-1200 : ON and if pressure > 25psi OFF - set schedule to OFF permanently until reset
1200-1800: OFF
1800-2200: ON and if pressure >25 psi OFF - set schedule to OFF permanently until reset
2200-2400: OFF
Basically I run my pump 8 hours a day, 2 4 hour sessions. My pump normally runs around 19-22PSI, and when it exceeds 25 it needs regenerated. I would like it to shut down the run schedule or simply not run that "portion" of the schedule if the previous pump pressure was >25psi, unless something is reset.
Is there a pressure switch I can use for this, or another way to tackle this situation?