I'm using Indigo 7.1.1 and have noticed an issue where the status of a couple of my devices are not being updated properly in the GUI. Specifically, I've been setting up a bunch of triggers, schedules, etc. for a multi-zone HVAC system. I have a Z-Wave Aeon MultiSensor 6 and an Insteon Wired Thermostat that are relevant to this discussion. I'm using triggers from temp changes in both units to control a few stages of cooling and heating. I have two questions. First, I've noticed that the status of both devices are really sporadic in Indigo. For instance, the MultiSensor is set to report changes every two minutes, I see the changes in the log but they are not updated in the GUI. They might update for a few minutes, then after a while of having the app open it just gets stuck on the last number. If I quit and reopen, it is correct again.
The same is true with the Inseton thermostat. I'm looking an Indigo right now and it's reporting that it's not running and is at 66 degrees, the thermostat is actually reporting 67 degrees at the unit. The current heat/cool status isn't updated either. If I quit and reopen the app, it will display correctly. It is pretty consistent behavior, it just doesn't seem to be displaying changes without quitting and reopening the app.