Aeotec Multisensor 6 V1.07 - Config Parameter
Posted: Sat Feb 16, 2019 5:15 amI am probably doing this wrong.....
I want to set an offset for the multi sensor temp.
It consistently reads about 1.5C above actual - I use a reference Thermometer to calibrate digital temp sensors.
All the Hue Temp Sensors each to do but the Aeotec requires a parameter setting.
The Device
The Manual
Setting the Parameter
Then Read back the Parameter
What stupid thing am I doing that is stopping g this from working - any ideas anyone?
I want to set an offset for the multi sensor temp.
It consistently reads about 1.5C above actual - I use a reference Thermometer to calibrate digital temp sensors.
All the Hue Temp Sensors each to do but the Aeotec requires a parameter setting.
The Device
- Mulisensor - Device.jpeg (19.35 KiB) Viewed 1213 times
The Manual
- Multisensor - Manual.jpeg (127.87 KiB) Viewed 1213 times
Setting the Parameter
- Multisensor - Save New Value.jpeg (62.46 KiB) Viewed 1213 times
Then Read back the Parameter
- Multisensor - read set value.jpeg (62.81 KiB) Viewed 1213 times
What stupid thing am I doing that is stopping g this from working - any ideas anyone?