Aeotec Multisensor 6 V1.07 - Config Parameter

I am probably doing this wrong.....

I want to set an offset for the multi sensor temp.

It consistently reads about 1.5C above actual - I use a reference Thermometer to calibrate digital temp sensors.

All the Hue Temp Sensors each to do but the Aeotec requires a parameter setting.

The Device

Mulisensor - Device.jpeg (19.35 KiB) Viewed 1201 times

The Manual

Multisensor - Manual.jpeg (127.87 KiB) Viewed 1201 times

Setting the Parameter

Multisensor - Save New Value.jpeg (62.46 KiB) Viewed 1201 times

Then Read back the Parameter

Multisensor - read set value.jpeg (62.81 KiB) Viewed 1201 times

What stupid thing am I doing that is stopping g this from working - any ideas anyone?

Have a look at this explanation -- there is a specific section to setting parameter 201 on v1.07. Once you wrap your head around it, it's not that bad.

Thanks, both......

Dave - it worked.

Will research how to update fw.




Sent from my iPad using Tapatalk