Vision MultiSensor ZP 3111EU-5

Just got a couple of these but they're only showing as motion sensors; the other functions are not showing. I've submitted a Device Report.

[matt (support)]

Thanks, we'll look at getting the device definitions added. Do you have a link to a PDF manual by chance?

Sure:

https://doc.eedomus.com/files/ZP3111-5_R0_20151113%20-%20VISION.pdf

[matt (support)]

We've added support for the Vision Multisensor (ZP3111) in Indigo 2022.2.0, which is now available.

Yes, I noticed, and re-synced them. Thanks Matt

I have a couple of these sensors and they're working fine, but the temp/humidity/illuminance reports are always published to the event log, despite the "Hide status messages" box being ticked in settings.

[matt (support)]

Can you copy/paste an Event Log window example? The checkbox to disable status reports should be preventing them I believe.

Code: Select all

4 Mar 2023 at 05:47:44
   Z-Wave                          received "Kitchen PIR Temperature" sensor update to 19.38 °C
   Z-Wave                          received "Kitchen PIR Humidity" sensor update to 44.49%
   Z-Wave                          received "Kitchen PIR Illuminance" sensor update to 1.39%

[matt (support)]

I think the problem is you didn't set the Hide status messages checkbox on all of the sensor devices that Indigo created. Sometimes that preference is only shown on the first (main) device in the group, but in this case you should see it in the device settings sub-dialog for each sensor device.

Quite right Matt - I didn't realise there was a box to check on each individual sensor device tab. Thanks!