- Posted on
Sun Apr 25, 2021 2:59 pm
-
matt (support)
offline
- Site Admin
-
- Posts: 21417
- Joined: Jan 27, 2003
- Location: Texas
-
There are a couple of configuration parameters for the ZW120 to reverse the on/off commands sent but in the version of the module I have I ran into a firmware bug that prevented them from working well (so I didn't add UI for them). You can, however, try manually setting them using the Interfaces->Z-Wave->Modify Configuration Parameter... menu item. Try setting both parameter 1 and parameter 3 to have a value of 1. Note you may have to press the button on the ZW120 to wake it for the parameters to be set. Check the Event Log window to see if it works.