found module included in controller with no matching device

There are apparently several modules in my controller that are orphans. How do I remove them? Likely from old devices or failed device installs.

Z-Wave connected to Z-Stick Plus (ZW090) interface on /dev/cu.usbmodem1464401 (firmware 1.01)
Z-Wave found module included in controller with no matching device (missing or disabled): 024 - General Thermostat (v2)
Z-Wave found module included in controller with no matching device (missing or disabled): 027 - Keypad Door Lock
Z-Wave found module included in controller with no matching device (missing or disabled): 036 - Notification Sensor
Z-Wave found module included in controller with no matching device (missing or disabled): 043 - Entry Control
Z-Wave found module included in controller with no matching device (missing or disabled): 044 - Entry Control
Z-Wave found module included in controller with no matching device (missing or disabled): 062 - Simple Meter
Z-Wave found module included in controller with no matching device (missing or disabled): 095 - Open/Close Valve
Z-Wave found module included in controller with no matching device (missing or disabled): 102 - Relay Power Switch
Z-Wave found module included in controller with no matching device (missing or disabled): 122 - Notification Sensor
Z-Wave found module included in controller with no matching device (missing or disabled): 123 - Notification Sensor
Z-Wave found module included in controller with no matching device (missing or disabled): 143 - Entry Control
Z-Wave found module included in controller with no matching device (missing or disabled): 145 - Entry Control

[jay (support)]

Create a new Indigo Z-Wave device and attempt to sync. When it fails, select the Interfaces->Z-Wave->Remove Failed Device from Controller menu item. You can just repeat that for all the failed nodes using the same Indigo device, then delete it.

Upgraded to 7.5. Then removed modules following Jay's instructions. Worked! Thanks Jay.