New Zwave Stick- How to replace old one best process?

Hello all

I've just received a new Aeotec Z-Stick Gen 5 to upgrade from a Gen 1 version, before I receive a new Z=Wave lockset. I only have 2 Zwave devices currently, Everspring Temp/Humidity sensors. What is the best process to remove the current Gen 1 stick and replace it with the Gen 5, without having to redo all my programming for sensors? I found the inclusion/exclusion process a little tricky when I had a sensor go offline, and I don't want to have to start from scratch with my current Temp Sensors.

Any tips or suggestions greatly appreciated.

thanks
Brent

[jay (support)]

Since you only have 2 devices, just exclude them from the old stick and include them with the new one (you can, in fact, exclude using the new stick). Then just reselect their node IDs in the device edit dialog and sync. All the config you have will stay the same since you didn't delete the devices in Indigo.

Thanks Jay. I'll try that. I know its not alot of zwave devices, but I have a lot of work into logic surrounding the temp sensors that I didn't want to lose.