Howdy All,
I have recently purchased this Z-Wave RGBW controller to test. It is not yet supported by Indigo.
https://www.monoprice.com/product?p_id=36511
Inclusion was straight forward and the device shows up as a "Dimmable Power Switch."
I can turn it on and off and dim it but I have no control over color.
After looking over the documents I figured out how to run the few scenes which are stored in the device using Indigo's "Modify Configuration Parameters" command - works fine.
Here's a shot of the parameters section of the manual.
My question is general in nature. How do we find other Z-Wave commands/parameters for any given device (not just this one) and how do we enter them into Indigo? Or put another way, how do we find and use raw Z-Wave commands for device x?
Here is a link to the full manual if you are interested.
https://www.google.com/url?sa=t&rct=j&q=&esrc=s&source=web&cd=&ved=2ahUKEwiP7O_ky6XrAhVGB50JHSYrBlAQFjAAegQIAhAC&url=https%3A%2F%2Fdownloads.monoprice.com%2Ffiles%2Fmanuals%2F36511_Manual_190410.pdf&usg=AOvVaw3rQIG-zZQVOP4pETjGmYSa
Thanks in advance!
Dana