Aeotc Multi Sensor 6. ZW100

I have been trying to deploy a couple of these devices at mt remote installation. I got them up and sort of working before I left

Three days ago I tried to update the setting using Inigo. Although I have had some slows success doing this, This time the devise is stuck with a red indicator and says Changing Pending.

I imagine I am going to have tp physically power cycle the device.

Any thoughts or prayers


thanks

[matt (support)]

Indigo should push any config/settings changes to the device on its next wake interval (as defined by the popup near the top of the settings dialog). Manually waking it should also cause the settings to push. I don't recall the exact steps to manually wake an ZW100. Might be a single tap on the set button, might be 3 taps or a tap-and-hold.

thanks matt .. i will give that a try in a couple of months

No joy.. power cable broke off removing doesn't respond under battery.. another roaring success