- Posted on
Fri Jun 14, 2019 4:53 pm
-
matt (support)
offline
- Site Admin
-
- Posts: 21417
- Joined: Jan 27, 2003
- Location: Texas
-
Hi Raoul,
By default Indigo always sends configuration parameter settings to the main/root endpoint in the module. In this case I wonder if the module is wanting us to send it to the secondary endpoints. That is, each endpoint (sensor in this case) might have its own configuration settings. I don't believe I've ever seen a module do that before, but that might be what is happening. So let's try sending raw commands to the specific endpoint devices to see if that works:
1) Choose the Interfaces->Z-Wave->Send Raw Z-Wave Command menu item.
2) Select the secondary sensor (not main) device from the popup.
3) For the Payload Bytes use:
0x70 0x04 0x02 0x05
That will attempt to set config parameter #2 to the value of 5, which might turn on the sensor reporting for every 5 minutes. So try that and then wait 15 minutes or so to see if any values are sent. If the module is battery operated then you will have to wake it before you send the raw command.
You can also try sending a command like:
0x70 0x04 0x01 0x05
which sets config parameter #1 to 5, which should send out new values whenever there is a 0.5° C change.
If none of that works then copy/paste the Event Log results of the raw commands into a reply for me. Note you can vary the value of the last byte in the raw command based on the setting you want.