I just added a z-wave controller to indigo. I paired a zwave plug to it. The plug happily reports the energy usage of my internet gateway.
I'd like to set up an indigo action group, such that whenever this plug is turned "off" it will wait one minute and turn back on. (this is in case I need to remotely reset the internet. I won't get stuck with an off modem).
I have a trigger set up such that 002 Relay Power Switch received "off"
but I can't figure out how to send an "on" command. Do I send a raw z=wave command back to the plug? If so, where can I find the codes? Is there an easier way?