MCO Pm2.5 Sensor

Works, not detected vendor / model, changing units (because of ppm / temperature / humidity supported)

Z-Wave received "Stairs 1st Floor PM2.5 Sensor" sensor update to 7.0 micro-g/m3
Z-Wave received "Stairs 1st Floor PM2.5 Sensor" sensor update to 26.5 °C
Z-Wave received "Stairs 1st Floor PM2.5 Sensor" sensor update to 39%

http://mcohome.com/show_list.php?id=15&sid=52
http://www.vesternet.com/downloads/dl/f ... manual.pdf

Could you please add proper support?

Z-Wave Syncing - started for "148 - Multilevel Sensor (routing)"
Z-Wave Syncing - retrieved module neighbors list: 3, 4, 5, 10, 12, 13, 19, 20, 21, 22, 23, 24, 25, 27, 28, 29, 36, 38, 39, 40, 46, 54, 57, 59, 60, 61, 62, 64, 65, 66, 67, 71, 82, 84, 85, 87, 88, 90, 93, 96, 98, 104, 108, 111, 115, 122, 126, 127, 130, 137, 141, 144, 159, 166, 175, 179, 180, 181, 182, 187, 189, 192, 201, 204, 218, 219, 220, 222, 223, 227, 228, 229, 232
Z-Wave Syncing - assigning return route to "148 - Multilevel Sensor (routing)"
Z-Wave Syncing - assigned return route
Z-Wave Syncing - retrieved manufacture and model names: Unknown - 015F, Multilevel Sensor (routing) - 0A050201
Z-Wave Syncing - retrieved protocol version 3.67, app version 1.00
Z-Wave Syncing - retrieved class hierarchy: Routing Slave : Multilevel Sensor : Multilevel Sensor (routing) (04 : 21 : 01, base 31)
Z-Wave Syncing - retrieved command classes: 20v1 31v5 72v1 85v1 86v1
Z-Wave Syncing - retrieved encrypt commands: - none -
Z-Wave Syncing - retrieved capabilities: routing, beaming
Z-Wave Syncing - retrieved group 1 associations: []
Z-Wave Syncing - added group 1 association to interface
Z-Wave Syncing - created device "148 - Multilevel Sensor (routing)"
Z-Wave Syncing - complete
Z-Wave received "148 - Multilevel Sensor (routing)" sensor update to 7.0 micro-g/m3
Z-Wave received "148 - Multilevel Sensor (routing)" units changed to micro-g/m3
Z-Wave sent "148 - Multilevel Sensor (routing)" status request
Z-Wave received "148 - Multilevel Sensor (routing)" sensor update to 7.0 micro-g/m3
Z-Wave received "148 - Multilevel Sensor (routing)" sensor update to 9.0 micro-g/m3

We think this is the only proper Z-Wave Air Quality Sensor.
So, besides all the other humidity sensors a good measurement of air quality is very important these days.
Please would you support this Air Quality Sensor in the next release of Indigo?

Thanks for all the work!

It (mostly) works today, wrong units shown but not a big deal.

Thanks for the feedback.
We have ordered one and let you know the results.
(or the stress of polluted air )

Works perfect!

[matt (support)]

Indigo 7.2.0 is now available for download and has Z-Wave support for the MCOHome Air Quality Monitor PM2.5 (MH10) and CO2 Monitor (MH9-CO2).