Aeotec Water Sensor 6 (ZW122)

I noticed in the release information for 7.1 the Aeotec Water Sensor 6 (ZW122) is listed as supported.

Is that a typo? I did not think it was available yet. Did you really mean to list the previous Aeotec Water Sensor pictured below?

[matt (support)]

No, they sent us a pre-release version of the ZW122 so we were able to add support for it now.

OK, thanks!

We are missing the Vibration part of this sensor in Indigo?
(https://aeotec.com/z-wave-water-sensor)
(bottom of the page)

[matt (support)]

We are going to look at adding support for both to Indigo. In the mean time you should be able to turn on Indigo's debug logging to see what messages it sends on vibration. If you do that then copy/paste the Event Log window results into a reply for me.

At your Service:


Z-Wave Debug RCVD requestAlarmSensorStatus: 01 0F 00 04 00 73 09 71 05 00 00 00 FF 07 03 00 01
Z-Wave Debug . . requestAlarmSensorStatus: node 115, endpoint None, cmdClass 71, type 0, value 0, classSubKey 710000
Z-Wave Debug . . requestAlarmSensorStatus: typeExt 7, valueExt 3, classSubKeyExt 7100000703

[matt (support)]

Thanks. While waiting for us to modify the device definition you could use the Match Raw Packet trigger type (after selecting Z-Wave Command Received), and choose your device in the From popup menu.

For the vibration trigger try a Match Bytes field like this:

* 0x71 0x05 0x00 0x00 0x00 0xFF 0x07 0x03 *

[matt (support)]

Indigo 7.3 (and 7.3.1) are now available and should support the tamper sensor on the Aeotec Water Sensor 6 (ZW122).