autolog wrote:The only way I could get it to work is to poll it on a regular basis by using Peter's
Z-Wave Sensor Logger
Brilliant tip thank you! I bought an SES303 with 3x the pipe slave temp sensors and have been trying to figure out what software I needed to use to get regular readings from the sensors. It's rather convoluted but this actually works! Nothing else I've tried does to date regarding hub software. I've not got all the data from the main and subsidiary sensors streaming from Domotics via MQTT to Node-RED on a Pi and then combined with other events onto an Initial State web-based event logger dashboard.
p.s. first post here, getting into Indigo Domotics... have lots of experience of IoT domestically and various other hubs incl. Hubitat, SmartThings, HomeKit, OpenHAB etc
Edit: the design of the SES303 hardware sucks (the backplate etc) so I've just got it loosely left on a horizontal surface where I can get at the switch if needed but with the pipe sensor connector on, without the wall bracket. Also the s/w implementation that by default only reports the main sensor readings not the pipe sensors double-sucks.