- Posted on
Mon Jul 10, 2017 11:38 am
-
Sharek326
offline
-
- Posts: 377
- Joined: Jul 20, 2014
- Location: Lansford, PA
Matt,
Still problems for mine. It included with encryption but fails when I sync. I have tried the step you listed above 5 times with same results My Sticker is 14247 Revision A Firmware 1.0
controller included module: 106 - Secure Barrier Add-On
Z-Wave querying module for encryption support
Z-Wave starting encryption key exchange with module
Z-Wave completed encryption key exchange with module
Z-Wave stopped controller inclusion mode
Z-Wave Syncing - started for "106 - Secure Barrier Add-On"
Z-Wave Syncing - retrieved module neighbors list: 3, 4, 5, 7, 10, 11, 12, 13, 15, 16, 17, 18, 21, 24, 25, 26, 27, 28, 29, 31, 32, 33, 34, 36, 43, 44, 45, 46, 47, 49, 50, 51, 52, 53, 54, 56, 57, 69, 86
Z-Wave Syncing - assigning return route to "106 - Secure Barrier Add-On"
Z-Wave Syncing - assigned return route
Z-Wave received "Meter Total" power load to 1191.181 W
Z-Wave received "Meter Total" energy total to 16.654 kWh
Z-Wave received "Meter Clamp 1" power load to 356.259 W
Z-Wave received "Meter Clamp 2" power load to 834.922 W
Z-Wave received "Meter Clamp 1" energy total to 8.527 kWh
Z-Wave received "Meter Clamp 2" energy total to 8.127 kWh
Z-Wave Syncing - retrieved manufacture and model names: LinearLinc - 014F, Garage Door Controller (GD00Z-4) - 47443030
Z-Wave received "Foyer Motion Sensor" status update is off
Z-Wave received "Media Room - Motion Sensor" status update is off
Schedule Total Energy (Kwh) Today
Schedule Total Power Currently
Schedule Total Power Currently C1
Schedule Total Power Currently C2
Z-Wave Error Syncing - failed
Z-Wave Error Timeout waiting for "106 - Secure Barrier Add-On". Module might be asleep, or is unreachable.