[ANSWERED] Everspring LOM-15

I have difficulties to get the evolve LOM-15 (from machomestore) receptacle to be recognized.

As usual I disconnect the z-wave stick, go to the module, press usb button for some seconds, then it starts blinking rapidly.
now I do either
-- tap sync button on LOM-15 or
-- double click sync button (as the manual describes (classic inclusion)
-- also tried press and hold

with then reconnect the usb stick to the mac and and add a z-wave device ... there is nothing in the Use node list, also refresh List does not show any device..


Have no clue what I am doing wrong.

I have 10 z-wave devices that work.

Karl

My mistake... i put the z-wave stick into exclude mode not include mode.

include: press usb stick once
exclude: press for several seconds.

if you end up with the Linear WO15Z-1 version of this the instructions say tap once, THAT IS WRONG , tap twice. It was a unpleasant day until I found the above exchange.

if you end up with the Linear WO15Z-1 version of this the instructions say tap once, THAT IS WRONG , tap twice. It was a unpleasant day until I found the above exchange.

Thank you so much for this post. You saved me a lot of frustration.