Indigo Domotics

DSC/Envisalink-3 moved to new computer and stopped working. See error messages below. Not sure what is going on:

Code: Select all

Jul 16, 2017, 8:17:30 AM
   Error                           script error: «script» doesn’t understand the “GetsxmStation” message. (-1708)
   DSC Alarm                       Initializing communication at address: 192.168.1.191:4025
   DSC Alarm                       Communication established
   DSC Alarm Error                 Connection RX Error: connection failed ([Errno 54] Connection reset by peer)
   DSC Alarm Error                 Connection TX Error: socket connection failed: [Errno 32] Broken pipe
   Error                           plugin "DSC Alarm 2.1.0" (pid 47914) unexpectedly stopped -- restarting in 5 seconds
   Reloading plugin "DSC Alarm 2.1.0"
   Starting plugin "DSC Alarm 2.1.0" (pid 47919)
   DSC Alarm                       Log level preferences are set to "Normal".
   Started plugin "DSC Alarm 2.1.0"
   DSC Alarm                       Initializing communication at address: 192.168.1.191:4025
   DSC Alarm                       Communication established
   DSC Alarm Error                 Connection RX Error: connection failed ([Errno 54] Connection reset by peer)
   DSC Alarm Error                 Connection TX Error: socket connection failed: [Errno 32] Broken pipe
   Error                           plugin "DSC Alarm 2.1.0" (pid 47919) unexpectedly stopped -- restarting in 20 seconds
   Error                           script error: «script» doesn’t understand the “GetsxmStation” message. (-1708)
   Reloading plugin "DSC Alarm 2.1.0"
   Starting plugin "DSC Alarm 2.1.0" (pid 47920)
   DSC Alarm                       Log level preferences are set to "Normal".
   Started plugin "DSC Alarm 2.1.0"
   DSC Alarm                       Initializing communication at address: 192.168.1.191:4025
   DSC Alarm                       Communication established
   DSC Alarm Error                 Connection RX Error: connection failed ([Errno 54] Connection reset by peer)
   DSC Alarm Error                 Connection TX Error: socket connection failed: [Errno 32] Broken pipe
   Error                           plugin "DSC Alarm 2.1.0" (pid 47920) unexpectedly stopped -- restarting in 20 seconds


I rebooted the Envisalink on its webpage software and that fixed the issue.

So I need to reactivate this. The problem came back after about 1 week of working Any ideas what would cause this problem to recur? Perhaps a temporary power failure?

Looks like network issues.

I seem to recall you get that message if something else is already connected to the Envisalink which can only handle one connection at a time (which is annoying as i now have 2.. one for Indigo and one for HomeBridge-Envisalink) so you might wanna check your old machine isn't establishing a connection. You could also try power-cycling your alarm system to reset the envisalink.

Also, remember, only one system can be connected to Envisalink. So when I transferred from one system to another, my Envisalink kept failing with the new system because it was still connected to the old one. Just throwing that out there in case it helps.