Page 1 of 1
Alarm LCD Line 1 only shows time/date...
Posted:
Thu Jul 02, 2015 8:03 pm
by russg
Hello all,
I am installing a new DSC 1864 (fw 4.6) with an EnvisaLink 3 on Indigo 6.1.0. I am integrating the DSC alarm plugin, and it works like a charm, with the only issue being that the 'LCD Line 1' and 'LCD Line 2' always show the Date & Time. They never update to show 'Exit Delay In Progress', 'Entry Delay in Progress', Faults, or any other message.
Any ideas what I'm doing wrong? Right now it's just a clock display.
Any ideas gladly accepted - russg
Re: Alarm LCD Line 1 only shows time/date...
Posted:
Thu Jul 02, 2015 8:21 pm
by RogueProeliator
Any ideas what I'm doing wrong? Right now it's just a clock display.
When you use the EnvisaLink, the actual LED lines are not sent for the plugin to update; I had thought they would too at first, but found the answer here on this forum in other post(s). I re-thought my control pages after that and went to more status updates (you can use the other various states to get all of the same information) such as buttons/lights that turn on or off on the page for "Ready", "Armed", etc.
Adam
Re: Alarm LCD Line 1 only shows time/date...
Posted:
Sat Jul 04, 2015 3:42 am
by durosity
Yeah, if you want the actual keypad status you'd need to get an IT-100 serial adapter.. Essentially it's the internal components of a keypad that connects to your Mac via rs233
Sent from my iPhone using Tapatalk
Re: Alarm LCD Line 1 only shows time/date...
Posted:
Wed Jun 08, 2016 8:23 pm
by Monstergerm
Also, it looks like the displayed time is often lagging behind the keypad time and does apparently not constantly getting updated.
Re: Alarm LCD Line 1 only shows time/date...
Posted:
Wed Jun 08, 2016 9:13 pm
by durosity
It should always be up to date (although there's a keybus bug that seems to delay the recorded time by 60 seconds)
Re: Alarm LCD Line 1 only shows time/date...
Posted:
Wed Jun 08, 2016 10:38 pm
by Monstergerm
I see up to 4 minute difference between system time and keypad. This is on a DSC panel. I think I will just use a time variable updated by Indigo instead.
Re: Alarm LCD Line 1 only shows time/date...
Posted:
Wed Jul 06, 2016 8:35 am
by travisc
The Envisalink devices only send a date / time broadcast every 4 minutes.
Re: Alarm LCD Line 1 only shows time/date...
Posted:
Wed Jul 06, 2016 9:45 am
by durosity
Nice to see you back travis! We were worried you'd went awol on us!
Re: Alarm LCD Line 1 only shows time/date...
Posted:
Wed Jul 06, 2016 10:14 am
by travisc
Ha, thanks! Having two kids definitely cut into the free time I once had but I'm still around.
Re: Alarm LCD Line 1 only shows time/date...
Posted:
Wed Jul 06, 2016 11:36 am
by durosity
Well just remember your babies here too