Indigo Domotics

I am getting this error when I turn on the DSC Alarm Plugin.
I have the Debug level set to Intense and this is what the log reports.
Here are the system specs: OS X 10.9.2, Indigo 6.0.11, Envisalink-3 Firmware Version: 01.11.128A, DSC Alarm Plugin 1.5.4, Vista 20p

May 14, 2014, 9:25:03 PM
DSC Alarm Debug validating Prefs called
DSC Alarm Debug STATE: Startup
DSC Alarm Log level preferences changed to "Intense Debug".
DSC Alarm Debug getConfiguration start
DSC Alarm Debug Configuration read successfully
DSC Alarm Initializing communication at address: 192.168.1.20:4025
DSC Alarm Debug RX: Login:
DSC Alarm Error IT-100/Envisalink Error: Received a response with invalid characters
DSC Alarm Debug TX: 005user54

DSC Alarm Debug RX: FAILED
DSC Alarm Error Checksum did not match on a received packet.
DSC Alarm Error Timed out after waiting for response to command 005user for 3 seconds, retrying.
DSC Alarm Debug TX: 005user54

DSC Alarm Error Timed out after waiting for response to command 005user for 3 seconds, retrying.
DSC Alarm Debug TX: 005user54

DSC Alarm Error Timed out after waiting for response to command 005user for 3 seconds, retrying.
DSC Alarm Error Resent command 005user 3 times with no success, aborting.
DSC Alarm Error Timeout waiting for Envisalink to respond to login request.
DSC Alarm Plugin will attempt to re-initialize again in 3 minutes.

Any assistance you can give would be greatly appreciated.

I guess Travis isn't working on this plugin anymore?

I suspect he's just busy - he's usually pretty good at getting back to people. He might have just missed this post.

The plugin supports the DSC message format. Although both DSC and Vista use the same electrical signaling, the plugin is likely not compatible with the Vista Message format, which is quite different.

Has anyone been successful integrating a Envisalink 3 with Vista 20p?

The Envisalink should work just fine with the Vista panel. But of course the DSC plugin will not work since it only supports DSC panels.

Will this plug-in work with the EnvisaLink 4?

Yep I use an envisalink 4 connected to a DSC system with the plugin.


Sent from my iPhone using Tapatalk Pro

durosity wrote:

Yep I use an envisalink 4 connected to a DSC system with the plugin.

Thanks.