- Posted on
Thu Apr 13, 2023 4:31 pm
-
sgtwicki
offline
-
- Posts: 44
- Joined: Oct 21, 2009
- Location: Massachusetts
I haven't payed attention to my EZRain (EZFlora) over the winter. When I went to go set it up today, I noticed my Indigo 2022.2 now thinks the device is an IR-Linc Transmitter. I tried deleting the device and adding it again, but I get the same results.
Here is the event log when re-adding the device:
PowerLinc Linking - entered discovery linking mode (240 seconds)
PowerLinc Linking - received module button pressed from 01.DB.EE
PowerLinc Linking - sending engine version request to 01.DB.EE
PowerLinc Linking - received engine version 01 from 01.DB.EE
PowerLinc Linking - sending id request for device information to 01.DB.EE
PowerLinc Linking - received id request response from 01.DB.EE
PowerLinc Linking - initializing remote device "new device" (address 01.DB.EE, firmware version 90)
PowerLinc Linking - initialize complete
PowerLinc Linking - syncing remote device "new device" (address 01.DB.EE, firmware version 90)
PowerLinc Linking - syncing of this device not possible remotely (skipping)
PowerLinc Linking - sync complete
PowerLinc Linking - syncing PowerLinc links (address 52.19.DE)
PowerLinc Linking - . . adding: INSTEON plc link to controller 01.DB.EE, flags 03, group 01, data 00 00 FF
PowerLinc Linking - PowerLinc links updated
PowerLinc Linking - sync complete