Gusten wrote:This should probably be in a separate thread, but this was the closes one.
Anyone know how the tamper is working?
I get this filling up my log, it almost one every second
Z-Wave received "027 - Tamper" status update is on
There is a specific ZW100-thread for Indigo 7 at
ZW100 on Indigo 7(@Matt: Maybe you can move Gusten's post and mine into that thread?)I have a couple of these ZW100's but haven't tested them yet on my system.
Have you upgraded yours to latest official firmware 1.07 according to
ZW100 firmwares(There is an unofficial beta 1.08 as well on the same page.)
I read through the manual (can for example be found at
ZW100 manual as well as the advanced config param manual at
ZW100 advanced config but I can't find any good info on the tamper/vibration sensor. Only information I find is what you already have found as well, i.e. tamper/vibration alarm goes off when the sensor is moved.
I saw in
this post that the ZW100 seems to have an extremely sensitive vibration sensor.
This leads me to think that yours either:
1. has a broken vibration sensor or a vibration sensor that is just tooooo sensitive
2. is there a wrong and a proper way to mount these that might cause the tamper/vibration sensor to be on all the time? For example if it is standing on a bench does it have to be in the proper direction (for example the action button has to be on the upper right when looking at it from the rear side)?
I will test my ZW100's this weekend.